Syscad Tutorial Section 4 3

Shows how to set up a Tank at a required pressure, with Vapour Liquid Equilibrium and also to split the flows out of the unit. Shows the different options available when configuring a Splitter in a Tie. This shows you how to enable the Splitter in a unit and select the Gas Vent option. Shows you how to enable the spitter sub-model in the Autoclave to remove all of the gases in the Vent stream. This example shows how to set up a Tank at a required pressure, with Vapour Liquid Equilibrium enabled. This example shows you how you can add Heat Exchange to the Reaction Editor. It briefly describes the different methods that are ...

This shows you how to set the pressure in a unit and enable Vapour-Liquid Equilibrium (VLE). This shows you how to add a species, in this case CO(g), to the Species Database. This example demonstrates how you can add a Sink to the Reaction Editor. This will remove the sink species from the unit. This shows you how to add a species with hardwired data into a Shows you how to add a species to the Project Configuraiton File. This shows you how to split flows from a unit using a General Model with Operation = Mass Flow.

Shows you how to add a species to the Configuration file. Also explains some of the Configuration functionality.