Media Summary: I ran the wires to the stepper motors, wired them in series and did a short 17mm/s 12.5mm Depth Of Cut Single Flute Upcut Dewalt 660, full RPM Slotting, and 45% stepover 0.4mm Finishing pass ... I promised a link in the video. I'm only on my phone now, but will add it later. You can search
Mpcnc Primo Test Move - Detailed Analysis & Overview
I ran the wires to the stepper motors, wired them in series and did a short 17mm/s 12.5mm Depth Of Cut Single Flute Upcut Dewalt 660, full RPM Slotting, and 45% stepover 0.4mm Finishing pass ... I promised a link in the video. I'm only on my phone now, but will add it later. You can search 12.2mm DOC, 8mm/s, slotting in plywood, 1/4" two flute up cut, full rpm 660. The coasters are made of walnut hard wood and Ecopoxy Flowcast epoxy resin.
