Badprinter2 01

BadPrinter2

This a first test of printing red rubber from Plastink (http://www.plastink.com). We bought some sample and test a simple small ...

After installed the new custom twinfan http://www.thingiverse.com/thing:128047 on the E3D hotends, one of the object that we ...

First test for the XY system of the

We are revising the "Mantis" extruder base, this is a prototype of the base piece with reinforced wall for the new shorter and more ...

This is the first "dry run" test with Z axis disabled and using a 0.4mm color pen to reproduce a gcode of a simple gear. The file was ...

Printing with one of the 2 new hot-ends We are testing speed. (I apologize for the bad focus)

Gear Bearing printed with

This is the second "dry run" test with Z axis disabled and using a 0.4mm color pen; this time we reproduce the gcode of our logo.

This is the first test of our custom design bowden extruder. It's a double extruder with simple design using two counteracting levers ...

This is our first test with the real motherboard using DVR8825 stepper drivers. The motors runs very smooth also with the first test ...

Printing test for double color.

We printed the "Fully assembled 3D printable wrench" http://www.thingiverse.com/thing:139268 After the white, we edit the stl file ...